How to make 3D Snowflake Christmas Trees.

One of my favorite new Christmas Dies this year is the

3D Snowflake Christmas Tree Die* from Sizzix.

The trees are so easy to make, and you can make a variety of trees

by removing or adding snowflakes.

*Disclosure:  This blog uses ads and affiliate links.  If you choose to make a purchase using one of the links, I receive a small commission (at no additional cost to you) that helps offset the costs of maintaining this blog.  Thanks for your support!

I made the retro-inspired tree using Silver and Red Metallic

Cardstock with silver beads as the spacers.  (It’s my favorite!)

These would look adorable on your Christmas table alongside each plate.

To make the 3D Christmas Trees…

Materials Used:  (*affiliate links)

• #662869 Sizzix Bigz Die-Snowflake Christmas Tree*
• Green Cardstock* and Gold Cardstock*
• Big Shot Die Cutting Machine*
• Thin Wood Stick (Walmart Craft Section for $1.27 for 50)
• Small Wood Beads (Hobby Lobby)

1. Die-cut three sets of green snowflakes.
2. Die-cut four sets of gold stars and the gold base.
3. Fold the four gold stars and gold tree bases in half. Glue the four sides together.
4. Place a little dab of glue on the bottom of the stick and place it in the center of the gold base.
5. Add a small wood bead onto the stick and alternate beads and snowflakes.
6. Leaving approximately ½”, cut the excess stick off the top of the tree.
7. Add a little glue to the top of the stick and add the gold star.

Add some twine to the top of the snowflake tree and hang it as a Christmas Decoration.